|
Build Your Online Product Catalogs?
Product Name: |
Portable battery tester with LCD screen display battery data
|
Supply Ability: |
10,000-20,000sets |
Related proudcts |
battery tester, battery ***ector, testing engineer, |
Specifications |
RFNT2 |
Price Term: |
|
Port of loading: |
Shenzhen |
Minimum Order |
1sets |
Unit Price: |
|
|
Basic Parameters ¡ó Dimensions: 201 x 99 x 35 mm ¡ó Weight: 333g ¡ó Adapter Input: AC 100 ~ 240 V Output: DC 19V 4.74A ¡ó Display mode Segment LCD with white backlight + LED in red and green ¡ó Charging mode Constant current + constant voltage ¡ó Charging current Maximum charging current of each channel: 2.5A ¡ó Standby power consumption ¡Ü1W ¡ó Working temperature 0~40℃ 20%£90% RH (Non condensation) ¡ó Storage temperature -20℃~65℃ 10%£95% RH (Non condensation) ¡ó Maximum charging time 8 hours
Function Introduction Charge Two channels can work independently and serve two intelligent batteries separately. Active, pre-charge, constant current and constant voltage are the stages of charging mode. The initial charging mode depends on the battery voltage, so active and pre-charge don't happen to every batteries. Test Testing time is 30 seconds and the purpose is to check both the charging and discharging performances. After finishing test, LED flickers with green colour and LCD reports the test result. Normal: Test OK Shown on LCD Abnormal: Test NG Shown on LCD Possible causes and solutions for the abnormal: 1) Cause: battery voltage is too low to discharge Solution: try to charge the battery to raise voltage 2) Cause: remaining capacity is too full to charge any more Solution: try to discharge the battery to reduce the remaining capacity 3) Bad contact of battery connecting wires 4) Damaged battery 5) Tester trouble Online Functions Tester can be connected with master machine via a USB port. Users can monitor, control and set parameters via Battery Manager software in the master machine. Others ¡ó Active cooling ¡ó Active batteries of zero voltage When a battery is deep discharged, the discharge protection circuit will start up and the voltage in the battery connector will become zero voltage. In this case, an appropriate voltage should be supplied to active the battery. ¡ó Battery identification Battery information can be read from battery management chip |
Company: |
NEW GIANT(HONGKONG) LIMITED
|
Contact: |
Ms. Elva Pi |
Address: |
Room 1518-1519,Dongming Building,Minkang Road,Minzhi Village,Longhua Town,Bao an District |
Postcode: |
518131 |
Tel: |
0755-83107575 |
Fax: |
0755-83107020 |
E-mail: |
|
|
|
|